Is Removing Popcorn Ceiling Worth It?

What is so bad about popcorn ceilings?

Herein lies the problem with scraping your popcorn ceiling off yourself; if your ceiling contains asbestos introducing the fibers into the air is when it becomes dangerous.

When asbestos fibers are inhaled, they lodge in the lungs and can cause diseases such as mesothelioma..

What is the advantage of popcorn ceiling?

Popcorn ceilings are better at noise insulation than smooth ceilings because of the increased surface area. In fact, it can be used in rooms where noise is an issue for the homeowner.

How do you remove a popcorn ceiling without making a mess?

For easier scraping and practically no dust during popcorn ceiling removal, use a garden pump sprayer to mist the ceiling and let it soak in for about 15 minutes before scraping. Only give it a light misting—too much water could damage the drywall or loosen the joint tape.

Why did they invent popcorn ceilings?

ANSWER: According to Pleasanton contractor, Jeff Debernardi, the ceilings were used to cut down on reflective noise and to cover up seams and tape marks in wallboard ceilings. The ceilings were usually was made of chalk and wallboard compound, but some mixtures contained asbestos.

How do you make popcorn ceilings look good?

9 Options to Remove, Hide or Play Down a Popcorn CeilingCeiling Scraping.Ceiling Replacement.Covering Stucco.Beadboard. Classic beadboard makes a charming ceiling treatment, and not just in a rustic cottage. … Warm wood. If you’re not into painted beadboard, try multitonal wood for a rich, inviting treatment that’s great for a den or sitting area. … Pressed tin. … Other Options.

How much should I pay to remove popcorn ceiling?

The average cost to remove popcorn ceiling is between $1,010 and $2,260 with most homeowners spending about $1,710. Contractors typically charge $1 to $2 per square foot for removal of popcorn ceilings.

How hard is it to remove popcorn ceiling?

Removing a popcorn ceiling is a fairly easy and affordable DIY project that just requires some time and muscle. Should your ceiling need more TLC than just scraping and painting, there also options for covering up popcorn ceilings, such as wood paneling, pressed tin tiles, or new drywall.

What is the next step after removing popcorn ceiling?

After you have scraped all the popcorn off, allow the ceiling to fully dry. If you scored an A+ in following my what not to do’s, you may not need to do this step. Those spots where I tore the paper on the drywall needed to be fixed. Lightly sand them to make them as even as possible, then spackle as needed.

Do I need to prime ceiling after removing popcorn?

After removing the popcorn, the ceiling should be sanded and bad seams and the dings need to be “topped off” After topping off and sanding, it is wise to prime the ceiling before trying to roll on texture. Bare drywall will suck the moisture out of the paitn and prevent you from distrbuting the texture evenly.

How can I tell if my popcorn ceiling has asbestos?

Asbestos isn’t dangerous if it’s undisturbed or contained, however….Testing for AsbestosFill a spray bottle with water mixed with a few drops of liquid detergent.Use a putty knife to cut out a sample.Seal it in an airtight container or plastic bag.Take the sample to an asbestos testing lab.

How do you get rid of popcorn ceilings?

When scraping popcorn ceilings, you’ll want to use a 4-inch utility knife or a drywall knife to chip away at the texture and create a smooth surface. You’ll probably need to skim it with a thin layer of joint compound to smooth out imperfections, then sand it smooth before repainting.

What sandpaper do you use for drywall?

Preparing Surface Start smoothing the surface by sanding with 100 grit sandpaper, 120 grit drywall sanding screen or a Medium grit sanding sponge. We recommend using an Extra Large Sanding Sponge.

Does removing popcorn ceiling increase home value?

Schutte estimates that removing a popcorn ceiling would add $25,000 to $35,000 in value for a large estate executive home. For a home of about 1,400 square feet costing about $200,000, he estimates an added value of about $2,500—essentially, close to what a homeowner might put into the project.